Story · 12 Nov
Leaving a phone on a library desk during exam week
Approved by the founder
How-to · 2 min read
A motion alarm on your phone is only useful if it goes off when someone picks the phone up and stays quiet when a truck drives past the café. If it screams every time the table shakes, you turn it off after one afternoon. And if it is too relaxed, someone can lift the phone and walk away before anything happens. Getting that balance right is most of the work.
Phones sit on very different surfaces, from a wobbly café table to a solid desk or a soft hotel nightstand. The same small movement feels like nothing on one and like a grab on another. Many alarm apps start watching the moment you tap the button, so the movement of your own hand putting the phone down counts as a trigger. And most give you no way to see how sensitive they are until the alarm actually goes off in a quiet room, which is the worst moment to find out.
This part describes the usual way. It makes no claims about MotionGuard, so nothing is quoted here.
MotionGuard is built around that setup step. Before you trust it, a visible sensitivity test shows how the phone reacts to movement on the surface where it will sit. When you arm it, a settle delay gives you time to put the phone down and step back before monitoring starts. The free version uses Normal sensitivity, and Pro adds Low and High presets for surfaces that need a different setting. While it is armed, the monitoring state stays visible, and you can disarm it from the app or from the ongoing notification when you come back. After a trigger, the local history shows what set it off, which sensitivity you used and the coarse movement it saw, so you can adjust for next time.
A visible sensitivity test lets you check how the phone reacts to movement before arming a full alarm.Quoted from its Google Play page
Choose a settle delay, tap Arm, and let the phone settle.Quoted from its Google Play page
Review when the phone was armed, what triggered the alarm, selected sensitivity, coarse movement evidence, charger state, and disarm time.Quoted from its Google Play page
Test on the exact surface you will use. A soft nightstand and a hard desk can react very differently to the same tap.
General advice. Not a claim about the product.
If Normal is too jumpy on a shaky table, Pro adds a Low preset. High is there for places where only a firm grab should count.
MotionGuard Pro adds Low and High presets.Quoted from its Google Play page
Leave the phone flat and away from the edge, so a passing bag is less likely to brush it.
General advice. Not a claim about the product.
Remember that it is an alarm, not a lock. It makes noise when the phone moves, but it does not stop anyone from taking it.
MotionGuard is a focused alerting utility.Quoted from its Google Play page
Yes. You can disarm it from the app or from the ongoing notification.
can be disarmed from the app or ongoing notificationQuoted from its Google Play page
No. The free core uses Normal sensitivity, and Pro adds Low and High.
Use the included Normal sensitivity for the free core. MotionGuard Pro adds Low and High presets.Quoted from its Google Play page
No. Continuous raw accelerometer traces are not kept.
Continuous raw accelerometer traces are not retained.Quoted from its Google Play page
Story · 12 Nov
Approved by the founder
Who it's for · 4 Nov
Approved by the founder
Guide · 4 Nov
Approved by the founder